May 01, 2018
Our new electronic element controller has been fully tested and will be available soon. This replaces our previous thermostatic model but has several other options such as float switch input so your brew kettle cannot run dry or be operated with sufficient liquid . This is a major improvement and saves the annoyance of burnt out elements as the element cannot be fired with the kettle empty. The new controller is built around the STC1000 electronic controller and uses solid state relays to switch the heating element, the unit comes in a stylish case and is supplied with all cables, sensors etc and a full installation and operation manual (in proper english). Keep an eye on our homepage the new controller will launch soon.